Question: Is it OK to put a hot tub on pavers?

Use caution when installing a hot tub on top of pavers. Hot tubs require a level base that is able to support the weight of the hot tub when it is filled with water and bathers. You can use a concrete slab, gravel, a deck or patio pavers as options to support your hot tub.

Can you put hot tub on pavers?

Patio Pavers Are The Ideal Support For Hot Tubs But before you run out to the hot tub store, consider where youre going to place it, and what youre going to place it on. Once the pavers are in place, they will sweep hydrostatic sand into the joints, and you can set your hot tub up as they leave your driveway.

How much weight can a paver patio hold?

Pavers can withstand at least 8,000 pounds of pressure per square inch before material failure. As previously mentioned, this makes pavers about four times stronger than poured concrete.

How thick should pavers be for a hot tub?

The recommended paver thickness is 2-4 inches. Synthetic Hot tub Pad – These premade pads have gained increasing popularity over the years as a quick and simple way of creating a hot tub foundation.

Can a hot tub be placed directly on the ground?

Outdoor hot tub placement, such as decks, concrete or brick patios, is common. However, the hot tub can be placed on any solid, uniform, level surface. Do not place your hot tub on grass or bare ground.

Can you lay pavers on just sand?

A thin final layer of setting sand is the actual surface on which you place the pavers. Larger paving stones act like building footings. In other words, compacted sand can provide a sufficient base for a paver patio thats just going to have you walking across it.

Are pavers high maintenance?

Most pavers require very little maintenance when properly installed. While there are several types of paving stone, such as concrete and clay, they are generally a durable surface to install for walkways, patios and pool areas.

Do you need a concrete slab for a hot tub?

A hot tub requires a stable surface — whether its a concrete slab, reinforced deck, or firmly compacted soil with crushed gravel. For concrete installations, you should go with a 4-inch-thick reinforced concrete base that can support 120 pounds per square foot.

How thick should sand be under pavers?

1 inch The amount of sand you use can make or break your paver installation, so its best that you use no more than the recommended 1 inch. Heres why: A sand layer that is too thick can create waves in your patio during the installation. Pressing pavers into a thick sand bed may result in misalignment and a messy look.

What is the best material to put under pavers?

The Interlocking Concrete Pavement Institute recommends washed concrete sand as the best base sand for pavers. Concrete sand, also known as bedding sand, is coarse and doesnt trap excess moisture beneath the paver surface.

Which pavers last the longest?

Although less strong than brick for bearing heavy loads of weight, concrete ultimately lasts longer, giving you 25-50 years of fairly heavy use before these pavers begin to erode. Concrete pavers are also stronger and more durable than concrete slabs that may crack or easily chip from normal use.

Is cement cheaper than pavers?

Standard concrete slabs are generally lower in cost per square foot than the alternative. Typically, you will pay 10%-15% more if you choose paving stones over standard concrete slabs. If you decide to upgrade to stamped concrete, paving stones will most likely cost you the same or even less in most cases.

Join us

Find us at the office

Apollo- Siders street no. 56, 49428 Moroni, Comoros

Give us a ring

Jessamyn Awalt
+48 152 183 376
Mon - Fri, 7:00-20:00

Contact us